how to install sharkbite fittings on old copper pipe

The pipe was not properly deburred prior to installation. The pipe was not properly deburred prior to installation.

Can I Use Sharkbite On Copper

Outer edge of the copper pipe must be reamed clean we advise to reamdeburr the inside also to reduce turbulence.

. SharkBite brass push-to-connect fittings are compatible with PEX Copper CPVC PE-RT and SDR-9 HDPE pipe. Replacing Copper Pipes and Fittings with SharkBite Push Fit Shut off water and drain pipe. I got it at the Home Depot but can be found on Amazon as well.

Avoid jagged ends with burrs. Installing SharkBite fittings on the copper pipe is easy and a do-it-yourself project. SharkBite fittings can leak due to one of these reasons.

Make a mark with the sharpie. The pipe has scratches or debris on the outside. 0008 Use auto-cut tool to cut pipe.

It needs a smooth surface to seal to. Slide the copper tube. SharkBite brass push-to-connect fittings are compatible with PEX Copper CPVC PE-RT and HDPE pipe.

The pipe was not squarely cut. The pipe has scratches or debris on the outside. Cut the copper pipe gradually.

If the pipe has a burr where it was cut the burr can cut the. Using the Greatest Plumbing Supply Ever. Inspect and clean the end of the pipe and the fittinginstall the new copper pipe into the.

CTS 095 58 in. Position the pipe side prong so its fully seated on the pipe. How to install sharkbite fittings to copper pipe.

Measure pipe must. Take a piece of copper pipe and slide it all the way into the safe seal. Cut the copper pipe such that the ends are clear and sharp.

Slightly turning the line push the pipe in the. Just pick your size and DIY it. Insert copper pipe in the Suitable SharkBite Fitting.

SharkBite fittings come with a PEX stiffener pre-loaded into the fitting. Click to see full answer. For installation simply slide the sharkbite onto the end of the copper pipe and tighten the clamp using the provided wrench.

Squeeze the handle to compress the release collar. Avoid jagged ends with burrs. The pipe was not squarely cut.

Spot the end of the first cut you made and measure in 1 inch. 0035 Make a second cut to remove valve. To connect the new SharkBite Shut-off Valve to the old Copper Tube use the SharkBite End Attachment.

SharkBite fittings can leak due to one of these reasons. SharkBite fittings come with a PEX stiffener pre-loaded into the fitting for PEX. Place the fitting side above the barrel of the SharkBite fitting.

Sharkbite copper pipe repair kit. It worked for me. Such pipe connectors are different from traditional sharks.

When installing SharkBite fittings ALWAYS measure and mark any copper pipe that the SharkBite fitting will be sliding onto. Sep 5 2008. SharkBite Push-Fit Pipe Connectors.

Pipe Insertion Depth Chart SharkBite Fitting Size Nominal Pipe Size Pipe. The sharkbite seals to the outside of the pipe with an o-ring.

Connect Pex To Copper Replace Copper With Pex Sharkbite